Arcadia,
CA, April 3, 2000 -- M Audio announces it is shipping the DMP2, a stereo
mic pre/direct box with low pass filter and phase inversion.
The
DMP2 addresses the critical link between a microphone or direct in and
your recording system. Designed to maximize fidelity and minimize noise,
the DMP2 provides you with a variety of tools, including 48v phantom
power, phase inversion, low cut filter, and balanced operation.
The DMP2 carries a suggested retail price of $249.95.
Features
-
2 independent XLR, fully balanced inputs
-
2 alternate, independent 1/4” unbalanced, high impedance inputs. These alternate 1/4” inputs are impedance matched for performance with typical electric guitars
-
Separate low cut filters for each channel with switch & LED indicator.
-
Separate gain controls for each of the two preamplifiers
-
Individual signal and clipping LEDs for each of the preamplifiers
-
XLR phantom power can be switched on and off for both of the mic preamps
-
Phantom power on or off LED indicator
-
Dual purpose independent 1/4” outputs which accept either tip-ring-sleeve plugs for balanced outs or tip-sleeve plug for unbalanced outs
-
Full 48 Volt phantom power
-
Phase inversion switch
-
Half rack size
Specs
-
Frequency Response: 10 Hz to 200 KHz, +0/-1 dB mic inputs 5 Hz to 200 KHz, +0/-1 dB line inputs THD + N: .0009% @ 1 KHz
-
Dynamic range: 130 dB Low Cut Filters: 72 Hz 3 dB cutoff, 18dB/octave rolloff Mic Gain: 66 dB max.
-
Mic Input Impedance: optimized for any 50 to 600 ohm mic/cable setup.
-
Guitar Gain: 46 dB max.
-
Guitar Input Impedance: 100 K ohms.
-
Weight: under 1/2 lb.
-
Power supply: 9 VAC
Source: M Audio/Midiman
Web Site: http://www.midiman.net